Hello again! Long time, no blog!
Threw this random DIY project together as I was recently thinking about how heavy my veil is, which means I may not wear it the entire reception. So, I thought of creating a hair flower.
- 1 sheet of felt (30 cents at Michael's)
- Glue gun and glue stick
- A couple feet of lace (found whole spool on sale at Joann Fabrics for $2.50. Forgot to measure exactly how much I used, but I'm guessing it's around 2 feet or so)
- Decorative button to use as center of flower. (Got mine on sale at Joann Fabrics for $2)
- Hair clip or pin to glue on back.
-Cut out 2 inch circle from sheet of felt.
- I cut my lace off of the seam but I imagine you could probably use it as is, but I liked the look of the flat lace.
- Using hot glue gun start gluing one long section of lace around the felt circle so that there is about 1/2 inch of lace hanging off the outside of the circle.
- Once you have completed one rotation around the felt circle, cut the lace where the edges meet.
Here's what it looked like at this point:
- Start gluing another section of lace onto the flower (cut lace length-wise to make thinner if you so desire. This should be based on how big your felt circle is and how wide your lace is) to make a smaller circle inside (and on top of) the this one.
- Glue a final even smaller circle of lace inside the second one. (hard to explain, but the final picture should hopefully explain it better than I can.)
- Hot glue your decorative button of choice into the middle of the flower covering the visible edge of the smallest lace circle that you just created.
- Finally, hot glue your hair clip or pin of choice onto the back.
You could glue a hair clip on the back like I did but there are also a lot of other possibilities. It could be attached to a headband, could be a broach with a safety pin on the back, or glue a long length of ribbon on the back and it could be a sash of some kind.